Tag Archives: hand sewing

Modern Hemming

I always thought that blind-hemming was the only hemming that was acceptable for clothes that would be worn out in public. Blind-hemming, to me, was done by hand. Imagine my surprise, and skepticism, when I found out blind-hemming can be done on a sewing machine! Some machines have a designated blind-hem stitch, some have attachments for blind-hemming.

Sewing machines became popular in the 19th Century, but lots of sewing was still done by hand. Hand-sewing is rather an art, wouldn’t you say? I love beautiful hand-embroidery, trapunto, appliqué, quilting. Those fancy stitches make plain old blind-hemming look like a country cousin. We are a couple that is also fascinated by what machines can do. So I decided to give blind-hemming on the sewing machine a try. As luck would have it, Skip had 4 or 5 new pairs of pants that mysteriously came in with no hems at all, and each pant leg was about 5 inches too long.

pants to hem craftsbyjennyskip.com

The first step was to get Skip to try them on and say where he wanted the length to be terminated. About a year and a half later, we were ready to go to Step 2: measuring the inseam.

pants inseam
measuring the inseam

Next, cut off the excess. You have to leave some length to make a cuff or turn under. I think a pants hem should be about 3/4 inch to 1 inch. My grandmother taught me that the 2nd joint of my index finger is about an inch long, so I can eyeball that distance as a rough measure.

cutting off excess
yikes, the cut-off. It’s a little scary.

What if I cut it off too short? Oops, I have done that before! To be safer, wash and dry the pants before hemming (if the label says you can do so; don’t wash them if it says: “dry clean only”), and make the inseam a little longer than you think it should be.

pants hem
fold up a hem, fold it up twice, and press

To sew the blind-hem by machine, you take the folded-over-twice hem and fold the outermost fold back in. My machine has a blind-hem foot and a blind-hem stitch that does about 4 straight stitches, then a side stitch, which is the blind-tack. If I were sewing the blind-hem stitch by hand, I would knot the thread, push the needle through the folded hem edge, then attach the thread to the pants with a tiny little stitch that can be barely seen from the outside of the pants, then grab a big stitch from the folded edge of the hem, and again, attach the thread to the pants with a tiny little stitch, grabbing only a thread’s breadth of the pants fabric with the needle.

blind hem foot
sewing machine’s blind-hem foot
Husqvarna Viking Diamond blind-hem setting
machine set up for blind-hemming
blind hemming by machine
Placement on throat plate for sewing the blind-hem

Sometimes people like to forget the pressing. But pressing is important; it makes the difference between shabby and sharp.

unpressed pants hem
These are the hemmed pants before pressing
pants hem
pressed pants hem

If you click on the last photo, and zoom up, you’ll be able to see the blind-tack stitches. They are more noticeable than if sewn by hand, but they look ok. They look good enough.